Livestock Products

Calf Shelter

With this design you can easily catch a calf inside using the flip-down gate, you can easily walk inside to treat sick calves, and spreading straw is fast and simple. Leave the whole side open and blow in straw or leave half-open for more wind protection.

One end contains a walk-through door. There are chains and/or tubing for attaching portable windbreak or freestanding panels to both ends. Put your shelter in the middle and a windbreak on each end for maximum protection. Skylights are along the side peaks to allow sunlight in. Calves won’t go in a dark shelter! With a tall peak, the inside of this shelter won’t heat up as much as shorter shelters. When calves get too hot and go outside in the cold, they get sick.

Overall Dimensions: 8′-6″ wide x 24′ long x 8′ tall.
Estimated weight: 1,800 lbs.
8′ gate centered with 8′ sheeting on both sides.
Roof skylights along both sides.
22ga Galvanized decking.
Outside edges are covered with trim.
28″ walk-through door can be open from inside and outside.
Lifting bar across the top allows you to pick it up from either side with a bucket.
Chain hooks in front and back for dragging.

Wind Breaks

Patented design allows you to rotate the legs without removing them. Legs are fastened to the windbreak so they will not fall out. Simply loosen the bolt and spin the leg. Panels can be lifted with a bucket or through the center with forks to gain extra height for clearing posts and fences.

24’ long by 8’6” tall
Average weight: 900 lbs.
Frame is constructed out of 2″ x 3″ x 11ga and 2″ x 3″ x 3/16″ Rect Tube
Legs are 12’6” long made of 3″ Sch40 well pipe and weigh over 100 lbs. each

Free Stand Panels

Panels are 5’9″ tall and stand 10″ off the ground.
2-7/8″ wellpipe is used to make the main frame and vertical uprights.
Five 1″ sucker rod are slid through the wellpipe for a stronger panel.
Rod is welded at both ends.
Sucker rod is spaced accordingly to help prevent calves from clawing through the bottom.
5′ arched or flat legs made from 2-7/8″ wellpipe
Legs can be welded on or made to swivel.
Two 3′ chains at one end and 4 slotted chain loop gussets in each corner.
24′ panels weigh about 800 lbs. and the 30′ panels weigh about 960 lbs.
Internal gates can be hung to make it easier for getting in and out of pens.
8′, 10′, and 12′ swinging gates can be hung on the ends. Gate hinge is designed so the gate can lay flat against the panel on one side and swing 90 degrees on the other.